Direction matters: important rules on how to paint surfaces
The repair is complete, the paint is dry, and stains become noticeable. You will learn how to avoid unwanted transitions in this article.
In what direction to paint the ceiling
First you need to prepare the surface. Remove all irregularities with a special grater. After that, it is advisable to walk through the ground.
Paint the ceiling from the window to the opposite wall. After drying, it is necessary to evaluate the result. If transitions are visible, apply the next layer perpendicularly, and the third again from the window to the wall. One strip of paint should slightly overlap the next. And the result is guaranteed.
In which direction to paint the doors
We are preparing the door for applying paint: we remove old impurities, putty on defects and cover with a primer. Just in case, you can protect the surface from swelling.
Apply the first coat. Let it dry well and cover the door with a second one. Coloring of a door leaf is better to begin with hard-to-reach spots: decorative elements. Do not forget to “pull” the paint from the joints and corners. Then, with the help of a roller or brush, we finish the work.
In which direction to paint the walls
Often the preparation of the surface for painting is similar. Therefore, we align the walls, but it is worth remembering that the filling of irregularities is required.
We pass along the walls with soil, wait about eight hours and begin to work. Apply the coating from top to bottom. This will help to avoid sagging. Let the paint dry and evaluate the result. If necessary, apply another layer in the same way.
It’s better to work with a roller, as unwanted stains remain from the brush.
In which direction to paint the floor
Now there are a lot of materials for flooring: laminate, linoleum, carpet. Painting is the most profitable way to refresh a boring room. If this method is for you, then you need to first get rid of cracks and bumps. To apply soil only on dry boards. Do not forget to protect the walls from getting paint on them, this can be done using masking tape.
Cover the floor in the direction of the fibers. After drying, evaluate the result. Usually 2-3 layers are enough. After a few days, you can see the result of the work.
